Features ：The corrosion of 6061 aluminium bus-bar caused by silicon can be completely avoided and controlled. As long as the raw materials and alloy components are effectively controlled the ratio of magnesium to silicon is within 1.3-1.7 and the pa

Features ：2A06 aluminum square bar/round bar is a typical hard aluminium alloy in the aluminium-copper-magnesium system. Its composition is reasonable and its comprehensive performance is good. Many countries produce this alloy, which is the largest

Features ：5A02 aluminium alloy bar is Al-Mg rust-proof aluminium alloy, which can not be strengthened by heat treatment. The magnesium content of the alloy is lower, its plasticity is higher, its forming type is lower, but its strength is higher than

Features ：The 5A05 aluminum square bar/round bar is an Al-Mg rust-proof aluminum alloy and cannot be heat-treated. The alloy has a high magnesium content and a low strength, similar to the 5A03 alloy. Cold deformation of the alloy can increase strengt

Features ：7A04 aluminum square bar/round bar belongs to Al-Zn-Mg-Cu super-high strength aluminium alloy, also known as super hard aluminium, which is quite mature in super hard aluminium and has been used for a long time and widely. 7A04 aluminum squ

Features ：Henan chalco 5040 aluminum alloy square bar Aluminum /round bar Use of aluminum row: The 5040 aluminum alloy rod is mainly used for high-quality plasticity and good weld ability. Low-load parts working in liquid or gaseous media, such as ma

Features ：3003 aluminum alloy is AL-Mn alloy which is the most widely used rust-proof aluminum. The strength of this alloy is not high (slightly higher than industrial pure aluminum) and it can not be heat-treated and strengthened. Therefore cold w

Features ：2A11 aluminum alloy is the earliest hard aluminum used generally called standard hard aluminum with medium strength. It has good plasticity in annealing quenching and hot state. It can be heat-treated and strengthened. It can be used in

Features ：EN AW 6101 T65 Aluminium flat bar produced by Henan signi Aluminum co.,ltd has a common thickness of 3.175mm, 6.35mm, 7.93mm, 10mm, a width of 38.1mm, 50mm and a length of 4000mm, 6000mm. It can produce EN AW 6101 T65 Aluminium flat bar rou

Features ：Comparatively speaking copper bus-bar is better arranged; compared with aluminum bus-bar according to the same length and section the carrying capacity of copper bus-bar is larger than that of aluminum bus-bar . Because the resistance of

Features ：6101 aluminum alloy, is American deformed aluminum and aluminum alloy. 6101 T4 T5 T6 aluminum flat bus bar have high-strength conductive material. 55% IACS guarantees good corrosion resistance and weldability for processing high strength bus

Features ：6082 alloy belongs to heat treatment strengthening alloy. It has good formability, weldability, machinability and corrosion resistance. It also has medium strength. It can maintain good operability after annealing. It is mainly used in mecha