7A04 Aluminium busbar bus bar

Current Position : Home/About us/ 7A04 Aluminium busbar bus bar

7A04 Aluminium busbar bus bar

Author:Frank  Time:2023-05-06
7A04 Aluminium busbar bus bar

Factory:

Specification:

Quantity:

Detail


7A04 belongs to al-zn-mg-cu ultra-high strength aluminum alloy, also known as superduralumin. It is a fairly mature superduralumin. It is an alloy that has been used for a long time and is widely used.High strength, good effect of heat treatment, medium plasticity in annealing and new quenching;Different from duralumin, the corrosion resistance of artificial aging state is better than that of natural aging state, and the natural aging process is slow, it takes 3 months to reach the peak of aging hardening, so 7A04 is used in the state of quenching artificial aging.Its disadvantages are low stability, low fatigue strength and stress corrosion.The spot welding of the alloy is good, the gas welding is bad, the machinability after heat treatment is good, but the machinability after annealing is not good.
 
 
Chemical composition:
Si:0.50
Fe: 0.50
Cu:1.4-2.0
Mn:0.20-0.6
Mg:1.8-2.8
Cr:0.10-0.25
Zn:5.0-7.0
Ti:0.10
Al:REM
Other:Single:0.05 ,Total:0.10
Mechanical properties:
Tensile strength (MPa) : ≥530
Yield strength (MPa) : ≥400
Elongation  (%) : ≥5
 
7A04 Aluminium busbar bus bar used in aircraft skin, screws, and stress components such as girder truss, frame, wing rib, landing gear, etc

CONTACT US
CONTACT US
Looking Forward to Your Response!

Mobile:86 17344894490

Email:service@signialuminium.com

Address:A126 Building 4, No.89 Science Avenue,National HI-Tech Industry Development Zone,Zhengzhou,Henan